.Pentax SP/SPII/SPF/Pentax K1000, LIGHT SEALS REPLACE KIT
This is Pentax SP/SPII/SPF/Pentax K1000 's Light Seals foam (backdoor gasket
sponge and Mirror Cushion), replace kit.
This seal kit covers Pentax SP/Pentax K1000 seals, shown as below.
These kits are readymade, you don't have to do anything in it(all cuts are already made in it),purchase
it and put it straightway to your camera.
Let's take a look that how many hours you have to spend for measuring foam seal size and cutting them if you do it by yourself?
(Actually I spent 2 hours for measuring data and cutting moulds).
STEPS FOR INSTALLING THE KIT (3 FOAM KITS ARE PROVIDED IN ONE SET)
Installing the kit on your camera is very simple, We have provided 3 foam kits in one set so you don't have to
worry if you waste one or two foam kit. we are sure that you will install perfectly for the 3rd time.
1,2. Remove the old light seals and clean up the residue of old seal from your camera with alcohol or benzine.
3. Take out the new light seal from the base paper.
4. Use cotton swab or paint brush to rub alcohol or water on the adhesive (sticky) side.
(The alcohol or water delays the adhesion and allows you time to position and adjust the seals.)
5. place the seals onto the narrow channel.
6. Use flathead screwdriver and adjust the seals before the alcohol get dry.
This kit only fits to Pentax SP/SPII/SPF/Pentax K1000, and does not fit
to any other cameras.
(Camera is not included in this kit.)
Asia : $7.40 US (registered airmail)
Europe & Oceania : $8.40 US (registered airmail)
South America & Africa : $8.80 US (registered airmail)
USA : $7.20 US (non-registered airmail)
Australia : $4.60 US (non-registered airmail)
Canada : $4.60 US (non-registered airmail)
Pentax SP/SPII/SPF/Pentax K1000 Light Seals replace kit