Minolta HI MATIC 7S Light Seals Replace Kit

This is a custom replacement kit for the Minolta HI MATIC 7s light seals (backdoor gasket sponge and mirror cushion).

Note: We are not sure if it fits the Minolta HI MATIC 7.

These kits are ready-made. You don't have to do any cutting or measuring; all cuts are already made for you. Just purchase it and apply it straight to your camera.

Note: 3 complete kits are provided in one set, so you can install it on 3 units, or use the spares if you make a mistake on your first try!

Installing the kit on your camera is very simple. We have provided 3 foam kits in one set so you don't have to worry if you waste one or two foam kits. We are sure that you will install it perfectly for the 3rd time.

1. Remove the old light seals and clean up the residue from your camera with alcohol or benzine.
2. Take out the new light seal from the base paper.
3. Use a cotton swab or paint brush to rub alcohol or water on the adhesive (sticky) side. (The alcohol or water delays the adhesion and allows you time to position and adjust the seals.)
4. Place the seals into the narrow channels.
5. Use a flathead screwdriver to adjust the seals before the alcohol gets dry.