Hasselblad 500CM custom covering kit quick installation guide

Remove the original covering and regidue then clean up and polish the surface very well as above photo.
As above 1st to 3rd images, take out the new leatherette from the base paper, and turn over the leatherette. Then wet the alcohol or benzine or water on the adhesion side (flesh side, not leatherette's surface) The alcohol (or benzine/water) delays the adhesion temporary and allows you time to position and adjust the skin, After the alcohol (or benzine/water) gets dry, adhesion cames back again.
As above "4th" image, squeeze the new leatherette under the tripod block, then adjust the position. Please apply the new leatherette before the alcohol gets dry.
As above 7th to 9th images, cut the front mask leatherettes along blue line, then apply the leatherette.
As for the waist level finder leatherette, squeeze under the hitch as 11th image, then adjust the position.
The rest of the procedures are the same as 1st to 12th.
after you applied all the new leatherette, wait a few hours until the alcohol gets dry.