How to replace the FX-3 covering
Please prepare following items.
It is easy to remove the original FX-3 skin, but if it is sticky, you can
pour a little alcohol into the adhesive like the photo above. |
|||
|
|||
1. If you have Rubber cement (bond), I recommend to rub the edge part, like the photo above. It will strengthen the edges. |
2. Rub rubber cement and dry it well. If you do not have rubber cement. Do not care. |
||
3. The difficult part is installing selftimer part. You need a little technique Take the covering (selftimer part) out from the base paper and reverse it. |
2. Rub alcohol with cotton swab on the tape side (sticky side). |
||
3. Start applying. |
4. Slide the covering under the selftimer while the alcohol wet. The alcohol delays the adhesion and allows you time to position and adjust the skin before alcohol gets dry. |
||
5.Adjust and position the covering before the alcohol get dry. |
6. Other parts is not difficult, just apply. |
||