1. Covering is provided like this. Please prepare following tolls Alcohol (Ether Alcohol) Brush flathead screwdriver				2. Reverse them.
3. Strip the exfoliation tapes on reverse side.				4. After stripped the exfoliation tapes, you just can see the sticky side like the photo above.
5. Dip alcohol on brush and rub on sticky side.				6. Please rub alcohol on green parts. Do not rub other parts. The alcohol delays the adhesion and allows you time to position and adjust the skin before alcohol gets dry.
7. Paste covering to the camera body.				8. You need a little technic for pasting on the back door side. First you fix covering on the round button(see allowhead).
9. Leave the green circle part, paste it later and fix the bottom allowhead part.				10. Please paste the order from 1 to 8.
11. Finally, you could start to paste green part.				12. Use flathead screwdriver, squeeze covering into the gap of film reminder.
13. After you squeezed, you could see like this.				14 Squeeze another side.
15. After you paste, please wait until alcohol gets dry (a few hours).
If you have Rubber cement (bond), I recommend to rub the edge part, like the photo above (red portions). It will strengthen the edges.